Owner`s manual

Page 7

T-knob

cast iron

router table

fence

nylon washer

spacer

3/8-16 x 2-1/2" hex bolt

14. Attach fence.

Use the (2) 3/8-16 x 2-1/2" hex bolts, (2) aluminum knob spacers,

(2) 3/8" nylon washers and (2) 3/8" (large) T-knobs.

15. Attach the dual position bit guard to fence.

Pre-assemble the guard with the (2) 1/4-20 x 3/4" hex bolts and

(2) knobs. Slide both bolt heads into the fence's T-slot to attach

to fence.

Note: The bit guard is designed for dual positioning. The larger,

curved side is used for general routing with small and medium

sized bits. The smaller angled side is intended for edge jointing

and small diameter bits.

12. Install dust port.

Pull the dust port along the two 45º grooves in the back of the

fence until it snaps into place. The port may fit very tightly.

13. Install the (2) MDF subfences onto the fence.

Insert (4) 1/4-20 x 40mm shoulder bolts into the counter-bored

recess on the subfences. Light pressure may be required to seat

bolts properly. The bolts are designed to fit snugly to prevent

spinning. Note: the subfences have no specific left/right or

up/down orientation.