Operator`s manual

4
Start with a Safe Work Area
Keep your work area clean and well lit. Cluttered
benches and dark areas invite accidents.
Do not operate power tools in explosive atmo-
spheres, near ammable liquids, gases, or dust.
Power tools create sparks, which may ignite the
dust or fumes.
• Keep bystanders, children, and visitors away
when using a power tool. Distractions can cause
you to lose control.
Electricity can be Dangerous
Grounded tools (three pronged cords) must
be plugged into a properly grounded installed outlet.
Never remove or cut off the grounding prong or modify
the plug in any way. Do not use any adapter plugs.
Double Insulated tools have a polarized plug
(one blade is wider than the other.) This plug will
t into an outlet only one way. Do not change
the plug in any way.
Do not use AC only rated tools with a DC power
supply.
Store battery packs away from other metal ob-
jects like paper clips, coins, keys, nails, screws,
or other small metal objects. These things can
make a connection from one terminal to the
other, shorting the battery terminals together
and causing burns or re.
• When using a power tool, don’t touch grounded
surfaces such as pipes, radiators, ranges and
refrigerators. There is a higher risk of electric
shock if your body is grounded.
In damp locations, only plug your tool into a
Ground Fault Circuit Interrupter (GFCI). If the
work area does not have a permanent GFCI
on the outlet, use a plug-in GFCI. Wear rubber
gloves and footwear.
Don’t use or leave power tools in the rain or wet
conditions.
Do not abuse the cord, carry the tool by its cord,
or pull the cord to unplug it. Keep the cord away
from heat, oil, sharp edges or moving parts.
Replace damaged cords immediately.
Always hold the tool by the insulated gripping
surfaces. Contact with hidden wiring or its own
cord will make exposed metal parts of the tool
“live” and shock the operator.
General Safety
All power tools can be dangerous if both general and tool specic safety instructions are not followed carefully. General
safety instructions apply to all power tools, both corded and cordless.
Rules about Extension Cords
• When using a power tool outside, use an exten-
sion cord marked for outdoor use with “W-A” or
“W”. These cords are made for outdoor use.
• Extension cords with 3-prong grounding plugs
must be plugged into 3-prong outlets when using
grounded tools.
• Replace damaged or worn cords immediately.
The wire gauge and length of the extension cord
must be able to handle the amps of the tool.
Find the Amps (A) on the tool’s nameplate and
use the chart to determine the necessary wire
gauge for your extension cord length.
16
16
16
12
Good Personal Safety is a Must
Following good safety practices when using all power
tools is a must. Make a habit of including safety in all of
your activities.
Always read and understand the tool’s opera-
tor’s manual, tool markings and the instructions
packaged with the accessory before starting any
work.
• Stay alert, watch what you are doing and use
common sense when using a power tool.
Do not use tools when you are tired or under the
inuence of drugs, alcohol, or medication.
• Dress right. Do not wear gloves, loose clothes or
jewelry. Contain long hair. Loose clothes, gloves,
jewelry, or long hair can be caught in moving
parts.
• Keep handles dry, clean and free from oil and
grease.
• Be sure the power tool’s switch is OFF before
plugging it in or inserting a battery pack. Do not
carry tools with your nger on the switch.
Remove adjusting keys and wrenches before
turning the tool ON.
Power Tool Institute | Phone: [phone] | Fax: [phone] | www.powertoolinstitute.com