Instruction manual

DAC2 DX Instruction Manual Rev A Page 24
AC Power-Entry and Fuses
Fuses
CAUTION: FOR CONTINUED FIRE HAZARD PROTECTION ALWAYS REPLACE THE FUSES WITH THE
CORRECT SIZE AND TYPE (0.5A 250 V SLO-BLO
®
5 X 20 MM – LITTELFUSE® HXP218.500 OR
EQUIVALENT). THE FUSE DRAWER INCLUDES TWO FUSES. ALWAYS REPLACE BOTH FUSES AT
THE SAME TIME.
Voltage Selection
THE DAC2 IS EQUIPPED WITH A UNIVERSAL POWER SUPPLY. THERE IS NO VOLTAGE SELECTION
SWITCH. AC VOLTAGE RANGE IS 88-264 VAC, 50-60 HZ. THE PRODUCT MAY ALSO BE OPERATED
FROM DC POWER OVER A VOLTAGE RANGE OF 125-373 VDC.
Power Cord
The AC power input uses a standard IEC type connector. One USA-compatible power cord is
included with DAC2 converters. IEC style power cords in country-specific configurations are
available in your locality.
CAUTION: ALWAYS USE A GROUNDED POWER CORD. THE PRODUCT IS EQUIPPED WITH A
STANDARD IEC POWER ENTRY MODULE. USE AN IEC POWER CORD THAT IS EQUIPPED WITH THE
APPROPRIATE CONNECTOR FOR YOUR LOCATION. CORDS ARE AVAILABLE FROM YOUR DEALER.