Instruction manual

DAC2 DX Instruction Manual Rev A Page 25
Internal Settings
Jumper-Configured Options
The following functions are jumper configured:
 XLR Output Pads
 Headphone Switches
 Headphone Gain
 Digital Pass-Through
Removing Top Cover
The DAC2 top cover must be removed to gain access to the jumpers. Do not attempt to remove
the faceplate or the rear panel.
CAUTION: The DAC2 contains static sensitive components. Static discharge may cause
component failures, may affect the long-term reliability, or may degrade the audio
performance. Use a static control wrist strap when changing jumper settings.
 Disconnect AC power by unplugging the power cord at the back of the DAC2 DX.
 Remove only the 8 screws holding the cover (4 on each side).
 Do not remove any screws on front or rear panels!
 Never remove the power entry safety cover in the rear corner of the DAC2 DX.
 Always connect a static-control wrist strap to the chassis before touching any internal
component.