Technical data

Page 8
Connection Details/Dimensions - 280 model
Figure 1.7
60
570 - Boiler Flow
605 - Heating Flow
650 - Combined Boiler/Heating Return
700 (including the door/clock)
640
605 - Domestic Hot Water
610 - Incoming Cold Supply
250
570
605
160
Connection Details/Dimensions
Diagrams opposite show the connection details
and dimensions for the BoilerMate A-Class SP
SOL appliance.
The BoilerMate A-Class SP SOL units are supplied
on an installation base to allow the pipe runs
to connect to the appliance from any direction.
It is easier if all pipes protrude vertically in the
cut out area shown. Compression or push fit
connections can be used. All pipe positions
are approximate and subject to a tolerance of
+/-20mm in any direction. A 15mm cold water
supply and a 22mm warning/overflow pipe
may also be required for the separate feed and
expansion cisterns if these are located in the
appliance cupboard.
Note: All dimensions are shown in mm and
are to the centre line of pipework/gland.
Connection Details/Dimensions - 300 model
Figure 1.8
00
000 - Boiler Flow
000 - Heating Flow
000 - Combined Boiler/Heating Return
770 (including the door/clock)
710
000 - Domestic Hot Water
000 - Incoming Cold Supply
000
000
000
000
Details to follow
in later issue
DESIGN
TECHNICAL DATA