User's Manual

711.0005 R1.1
7
USING SMARTIRE FOR COMMERCIAL SYSTEMS
GETTING STARTED
When your vehicle is started, your SmarTire system will power
up and the Full Function Display (FFD) will briefly flash all of its
screen icons, and flash the alert light. The system will then go
into stand-by mode, waiting for tire data from the sensors. When
your vehicle is driven over 6 mph (10kph), the SmarTire will
begin to receive tire data. When all of the tire icons are filled in,
the SmarTire has captured data from all of the tires.
NOTE: The system will not display tire data until the vehicle
has been moved. SmarTire starts to receive tire data only
AFTER your vehicle is driven ABOVE 6 mph (10 kph).
When viewing tire data for an RV / tow vehicle, the programmed
wheel positions are displayed in a vehicle icon. When viewing
tire data for a trailer or towed vehicle, the windshield graphic
disappears and the vehicle icon becomes a trailer icon. The
system will alternate views between the towing and towed
vehicle when operating with this configuration. The diagram
below illustrates the differences between the two viewing modes.
USING THE FULL FUNCTION DISPLAY
To display tire data for a specific wheel position:
1. Press the TIRE button to scroll through each of the wheel positions.
2. Press the MODE button to scroll through the pressure, pressure deviation and
temperature readings for each selected tire.