User's Manual

SmarTire Systems Inc.
Tire Monitoring System Reference Manual
6/13/2000 Page 37 of 55
This manual is under review by SmarTire – DO NOT ISSUE
Learn
This mode is used to add or remove transmitters from the
system.
Press the MODE button to select the learn mode icon. The
currently installed positions are indicated with the tire outlines.
Press the TIRE button to display the ten possible wheel
positions for the towing vehicle. The currently installed
transmitter positions are now indicated with a filled in tire
indicator.
The outline of the wheel position to be programmed will flash.
Use the TIRE button to scroll to the desired position.
To add a new transmitter ID at the selected position provoke a
transmission from the transmitter. A beeper chirp and rapid
flashing of the alarm light indicate a valid packet was received.
The new ID is stored.
To remove the transmitter of the selected tire location press the
MODE button.
If more than one tire location contains the same sensor ID, the
display will prompt an error with the conflicting tires filled in.
If no error is found, the tire map and the sensor type flags in the
custom vehicle profile is updated. This operation is logged to
the black box. All the fault flags and diagnostic counters stored
in the EEPROM will be cleared. The system will reset and go
to Stand-By mode.
WARNING:
Make sure that no transmitter other than the desired one has transmitted before moving on to the
next tire location or exiting this mode.