User's Manual

SmarTire Systems Inc.
Tire Monitoring System Reference Manual
6/20/2000 Page 37 of 56
This manual is under review by SmarTire – DO NOT ISSUE
Learn
This mode is used to add or remove transmitters from the
system.
• Press the MODE button to select the learn mode icon. The
currently installed positions are indicated with the tire
outlines.
• Press the TIRE button to display the ten possible wheel
positions for the towing vehicle. The currently installed
transmitter positions are now indicated with a filled in tire
indicator.
• The outline of the wheel position to be programmed will
flash.
• Use the TIRE button to scroll to the desired position.
• To add a new transmitter ID at the selected position
provoke a transmission from the transmitter. A beeper chirp
and rapid flashing of the alarm light indicate a valid packet
was received. The new ID is stored.
• To remove the transmitter of the selected tire location press
the MODE button.
• If more than one tire location contains the same sensor ID,
the display will prompt an error with the conflicting tires
filled in.
• If no error is found, the system will reset and go to Stand-
By mode.
WARNING: Make sure that no transmitter other than the desired one has transmitted before
moving on to the next tire location or exiting this mode.