User's Manual

SmarTire Systems Inc.
Tire Monitoring System Reference Manual
6/20/2000 Page 49 of 56
This manual is under review by SmarTire – DO NOT ISSUE
LCD unit Installation
The LCD unit comes in two models, one which integrates into the base receiver by clipping to its
front panel and other type which is connected remotely to the receiver via a 6’ cable.
To install the either LCD type, first remove the front bezel of the base receiver. Plug the LCD-I
type in place of the bezel.
Remove bezel from receiver Clip LCD-I onto front of receiver
For the remote version plug one end of the cable into the exposed connector on the base receiver
and the other end into the back of the LCD-R type. Observe proper polarity.
Receiver cable end plug LCD cable end connection
Power Shoe Installation
• Plug the power shoe connector into the cigarette lighter or an auxiliary plug in the
vehicle.
• Remove the battery cover from the back of the receiver.
• Push the receiver onto the power adaptor.
• Adjust the power adaptor flexible arm to a convenient viewing angle.