Specifications
5.
Select your waypoint
1
radial
(255.0”)
by first depressing the DATA
button. This will cause the radial for the previous waypoint
1
to
appear in the data display over the annunciation “RAD”. Select
your radial
(255.0)
with the data input controls. The outer knob
controls the
10”
and
100”
digits; the center knob “in” position
controls the
1
O
digit and the center knob “out” position controls
the
0.1”
digit.
6.
Select your waypoint
1
distance
(20.0
nm) by again depressing
the DATA button, causing display of the previous waypoint
1
distance in the data display over the annunciation “DST”. Select
your distance
(20.0
nm) with the data input controls. The outer
knob controls the
10
nm digit, the center knob “in” position
controls.the
1
nm digit and the center knob “out” position controls
the
0.1
nm digit.
Note that throughout this sequence,’the number
“1”
over DSP
annunciation will blink. It will stop blinking and remain steady only
when the waypoint number in
“DSP“
is
the same as the waypoint
number in
“USE”.
This is a safety feature.
waypoint
1.
That completes selection and storage
of
all data for
13