Specifications

Change over to waypoint 2
13. At 30 nm outbound from waypoint 1, you decide to change over to
waypoint 2:
Depress the DSP button and the number 2 will appear
(blinking) over the DSP annunciation and your waypoint
2
frequency will appear in the data display. Your DME display will
not change because waypoint 1 data is still “in use.” At this point,
if you desire, you can recheck your waypoint
2 radial and
distance data in the data display by depressing the DATA button
for each.
data “in use”. The number
2 will appear in the USE annunciated
space; the number
2 in the DSP space will stop blinking.
Waypoint
2 frequency (1 16.90) will automatically appear.
Following VOR/DME receiver acquisition of your new
VORTAC frequency, your distance display will begin reading
distance (NM), groundspeed (KT) and
TTS (MIN) to waypoint 2.
Your CDI TO/FROM flag will move to the TO position and you
can continue flying your course directly to waypoint
2.
When satisfied, depress the USE button to put waypoint 2
Flying direct to a VOR/DME facility
to fly direct to Springfield VORTAC.
2 frequency, so all you do is depress the VOR button.
14. You are approaching waypoint 2 and decide (or are instructed)
You are already tuned
to 116.90 SGF which is your waypoint
CAUTION: When flying directly to or from a
VORTAC facility, it
is preferable to select either
the
VOR or VOWPAR mode.
17