User's Manual

Fault Isolation Procedures
Code 16
(SID 11, FMI 2)
2-44
Code 16 (SID 11, FMI 2) Left Side Sensor
Step A Procedure Condition Action
Step B Procedure Condition Action
1. Key off.
2. Is vehicle equipped with a
Left Side Sensor?
1. Key off.
2. Disconnect 3-way stub connector
at the Left Side Sensor.
3. Key on.
4. Measure voltage between:
• Pins A and B.
• Pins A and C.
If the vehicle has a Left Side
Sensor
If the vehicle does not have a
Left Side Sensor
If voltage between pins A
and B is 1.8 to 2.5 volts and
If voltage between pins A
and C is 7 to 7.5 volts
If voltage is outside of range
Go to Step B.
The Central Processing Unit
has been programmed for a
Left Side Sensor. With a
PC-based or Hand-held
Diagnostic Tool, place the
Left Side Sensor option in
“NO” position. Go to Step V.
Replace Left Side Sensor.
Go to Step V.
Go to Step C.
VOLT
V ACOM
VOLT
V ACOM
B A
C
B A
C