User's Manual

13
1
1
3
4
6
2
5
Service Instructions
This check is done after the pads have been removed. See the
section on "Replacing Pads".
Check the sliding motion of the caliper on the slide pins. If the
caliper does not slide freely on the pins, make sure the move-
ment is not obstructed by external dirt or foreign objects.
Measure the play in the outer slide pins as follows. The
maximum amount of play is 1.0 mm [0.04 in.].
1. Attach a magnetic stand, complete with a dial indicator to
the frame.
2. Put the tip of the dial indicator on caliper at point 2, see
below.
3. Rock the caliper and read the dial.
4. Repeat this measurement procedure inside the brake disc for
the inner slide pins and measure at point 5, see below.
Checking Sliding Function Checking Play in the Slide Pins
1 – Caliper
1 – Outer slide pin 4 – Carrier
2 – Dial indicator tip 5 – Measure point
3 – Inner slide pin 6 – Dial indicator
Service Instructions