User's Manual

14
2
1
2
3
1
Max.
50 mm
[2.2 in.]
Service Instructions
Check the protection caps and rubber boots of the slide pins
[two (2) per slide pin]. If there are signs of cracks or other
damage on the rubber bellows and protection caps, they
must be replaced.
If action is required, see the section on "Replacing Slide Pins,
Slide Bushings and Boots".
1. Using an 8 mm socket, rotate the readjustment shaft until the
protection springs are fully visible.
IMPORTANT: Thrust plates should not exceed 50 mm
[1.97 in.] from the cover.
2. Inspect the protection springs. The protection springs must be
replaced if there are signs of cracks or other damage.
3. Pull back the protection springs and inspect the rubber
bellows. The rubber bellows must be replaced if there are
signs of cracks or other damage.
4. Turn back the readjustment shaft. Do not tighten the shaft.
If action is required, see section "Replacing Disc Brake".
Checking Boots for Slide Pins Checking Bellows for Adjustment Screws
1 – Slide pin protection cap
2 – Slide pin rubber boots
1 – Thrust plates
2 – Cover
3 – Protection springs