User's Manual

Service Instructions

1. Lift and support the axle in accordance with the vehicle

manufacturer's instructions.

WARNING: Follow the Safety Instructions. The vehicle

manufacturer's instructions must also be followed.

2. Check that the wheel can be turned freely.

3. Remove the plug.

4. Release the brake by turning the readjustment shaft using

an 8 mm socket (3/4 turn).

Note: The brake can be released in the counterclockwise

direction.

5. Position disc brake with the brake chamber at the top

and viewed from the side on which the hexagon of the

readjustment shaft is accessible, turn the readjustment

shaft counterclockwise.

6. Leave the wrench in the same position.

7. Activate the brakes ﬁ ve (5) times. The wrench must move on

each brake application which shows that the self-adjustment

is working.

Operating Test

IMPORTANT: Movement of the wrench must not be

obstructed. If the wrench moves to and fro or does not move

at all, the caliper is defective and must be replaced.

See the section on "Replacing the Disc Brake".

Release

Counterclockwise

Service Instructions