User's Manual

20
2
3
1
3
2
1
Replacing Slide Pins, Slide
Bushings, & Boots
1. Put the disc brake assembly in a vise. 3. Remove the four (4) bolts for the slide pins using Torx E 18
socket.
Removing Slide Pins, Slide Bushings, and
Boots (Frame)
1 – Protection cap 3 – Caliper
2 – Carrier
1 – Slide pins 3 – Carrier
2 – Caliper
2. Remove protection caps using a hammer and chisel. If the
inner part of the protection cap remains in the slide pin,
remove this using an internal bearing puller.
Note: Protection caps must never be reused.
4. Retract the slide pins suffi ciently to remove frame from caliper
by alternately pushing frame to and fro. If slide pins are
seized in the frame, cut threads internally in slide pins using
an M16x2 thread tap.
WARNING: To prevent injury, only grip from outside.
!