User's Manual

23
1. Install boot in caliper. Use Haldex tool #81922
(1-800-643-2374).
2. Press the outer part of boot into position in the groove in slide
pin and secure with boot ring.
WARNING: To prevent injury, only grip from outside.
Replacing Boots in Caliper
1 – Caliper 3 – Boot
2 – Slide pin 4 – Boot ring
1 – Lift carrier
2 – Caliper
1 – New protection caps
1
2
3
4
1
2
1
Socket
Extension
Replacing Slide Pins, Slide
Bushings, & Rotors
3. Clean the contact surfaces between the brake pads, frame,
caliper and on thrust plates. Use wire brush. Do not grind.
4. Apply anti-seize compound to the inner surfaces of the slide
pins facing the frame.
5. Push slide pins out so that frame can be fi tted into caliper.
6. Life frame into position in caliper and press slide pins into
position. Take care not to damage boots.
!
7. Apply anti-seize compound to the threads of the four (4) bolts
and screw them into position. Tighten with torque wrench
(Torx E 18 socket) to specs on page 5.
8. Tap new protection caps into position in the outer ends of the
slide pins using a 17 mm socket and extension.
Replacing Slide Pins, Slide
Bushings, & Rotors