User's Manual

2. The precise location to install the camera bracket varies

based on the vehicle make/model. See Figure 2. Find

the horizontal offset “A”, and vertical offset “B” for the

vehicle. The intersection of "A" and "B" will line up with a

notch in the windshield bracket during installation. When

measuring for the window bracket placement, measure

from the center of the windshield and from the solid

black area at the top. For vehicles with split-windshields,

measure from the middle of the center divider. For one-

piece windshields, typically there is a graphical indicator

to show the middle point.

3. Useameasuringtapeandne-tippedpentomarkon

the windshield the installation point for the bracket.

4. See Figure 2 Removetheplasticlmfromtheadhesive

on the windshield bracket. Place a small level on the

leveling tabs. Touching only the top edge of the bracket

totheglassatrst,alignyourmarkwiththenotchinthe

bracket. Adjust the angle of the bracket until it is level,

then carefully bring the rest of the bracket into contact

with the glass, making sure that the notch remains lined

up with the point marked on the glass. While it is lightly

seated, verify again that the bracket is level — at this

point some adjustment is still possible. Once you have

conrmedthatthebracketiscompletelylevel,pressit

rmlytothewindshieldfor10secondstoensureagood

bond.

5. Install the camera onto the mounting bracket and route

the harness to the compartment above.

PROCESSOR PLACEMENT

1. The processor will typically be mounted on the passenger

side of the vehicle in a front overhead compartment.

When selecting the ideal location, be sure to consider

that there must be no pinching or binding of the camera

cable, and that there should be easy access to all of the

unit's connections.

2. It is recommended to position the processor unit so that

the large connector is oriented to the passenger side of

the vehicle. A good practice is to leave 12 in. (or more)

of excess harness on the connector side for a service

loop.Theprocessorshouldbemountedat,usingthe

hook-and-loop-fastener pad to attach it to the vehicle.