User's Manual

8
Connections from the Vibrating Seat Motor Side
Using Delphi connectors, install the vibrating seat motor
wires into the smaller section of the connector. The black
wire from the right motor goes into slot C, the black wire from
the left motor goes into slot A, and the two red wires from the
motors are joined together and go into slot B of the Delphi
connector that is supplied with the kit.
The seat cushion can now be replaced. Use wire loom
protectors for any exposed wiring.
Connections From the Harness Side
This connector supplied has a red wire already installed
into slot B; this wire must connect to a good 12 Volt ignition
source protected by a fuse or circuit breaker with a current
ratingbetween5(ve)and15Amps.
Using Delphi connectors, install the pink wire into slot A and
the brown wire into slot C. The pink wire is used to control
the left vibrating seat motor and the brown wire controls
the right motor by supplying the motor with a ground. Join
the two halves of the connector together. Use wire loom
protectors for any exposed wiring.
FINAL STEPS AND SYSTEM TESTING
Install the Driver Information Sticker in a suitable location on
the vehicle, visible to the driver.
Return all vehicle panels and wiring looms to their installed
positions.
Restore the battery connections.
When the vehicle power is switched on the Autovue
®
LDW
system by Bendix CVS will go through a self test:
• If equipped with speakers, you will hear a chirp from the
left and right speakers respectively, in that order.
• If equipped with vibrating seat motors, you will feel a
short pulse from the left and right motors respectively,
in that order.
Both the green and yellow indicator lights on the Enable/
Disable switch should remain on. Both the green and yellow
lights should remain on until you reach 38 to 40 mph (61 to
64 km/h), at which point the system is active.
Test drive the vehicle (both day and night where practical).
Enable/Disable Switch Lamp Behavior:
Situation
Warning
Enabled
Lamp
(Green)
Status
Lamp
(Yellow)
Warnings
Ready
Vehicle Speed
< 37 mph
(60 km/h)
ON ON No
Can’t Find Lane
Markings
ON ON No
Vehicle Speed
> 37 mph
(60 km/h) AND
Lane Markings
Found
ON OFF Yes
Driver Presses
Switch to
Disable
Warnings
OFF OFF No
System
Diagnostic
Trouble Code
(DTC) Set
OFF ON No
TROUBLESHOOTING:
At start-up, if the green light on the Enable/Disable switch
illuminates and then goes out after a few seconds, this
typicallyindicatesthatthesystemisnotndingtheJ1939
CAN Bus data link. If so, test the following:
1. Check for loose connections to the data link wiring.
2. Use PC diagnostics to check the J1939 CAN Bus.
Two much more rare possibilities are:
3. The J1939 CAN Bus is not activated. Typically the J1939
CAN Bus can be activated via the engine diagnostic port
using a laptop, or diagnostic computer.
4. The vehicle does not have the J1939 Bus wiring run
from the engine ECM connector or Vehicle Control
Unit. Consult the OEM documentation for the correct
procedure to permit J1939 communications. Where this
is necessary, the two 120 Ohm resistors are supplied in
the kit to be used— if necessary — to assist with obtaining
the 60 Ohms required across the yellow and green wires,
so that the ECM recognizes that the J1939 Bus is in use.