User's Manual

5.3.1 Brake Wear Check using Guide Pin (For all Axial and Radial Disc Brakes except those listed in

Section 5.3.2 - These Callipers do not have the rib in position B (see also Section 5.3.2)

M+P-KN-005

Pad conditions can be visually inspected without

removing the road wheel by noting the positon

of the Floating Pin (4) in the Caliper (1).

If dimension ‘C’ is less than 0.04in. (1mm), a more

accurate check of the Pads and Disc must be

B = without rib (see also Section 5.3.2)

C = pin protrusion - shown in new condition

D = minimal pin protrusion - Pads and Rotor must be

checked with road wheel removed

If necessary change the Pads - see Section 6

completed.