User Guide

7
Vehicle Harness (piece no. 5010260, service piece no.
801157) – The vehicle harness is approximately 12 feet
long and provides power to the XVision
®
system. The harness
is made of a twisted tri-wire, which needs to be fused to the
vehicle ignition and headlamps. The harness has one 3-pin
connector that connects to the display harness.
The vehicle harness is not designed to be mounted externally.
After the harness is routed and secured with cable ties, the
excess wire should be removed and the fuse holders
installed. See Figure 10 and Table 3.
Jumper Harness (piece no. 5010441, service piece no.
801152) – The jumper harness acts as an “extension cord”
when the display and IR camera are mounted more than six
feet apart. The harness has two 8-pin connectors, one
connects directly to the IR camera harness and the other to
the display harness. The jumper harness is not designed to
be mounted externally. See Figure 11 and Table 4.
FIGURE 10 - VEHICLE HARNESS
TABLE 3 - VEHICLE HARNESS PIN OUTS
FIGURE 11 - JUMPER HARNESS
Harness Hardware – Two fuse holders, three butt splices,
a 1 A fast open fuse and a 3 A slow open fuse are all included
in the harness kit. Labels are also included and must be
applied to the fuse holders after installation.
TABLE 4 - JUMPER HARNESS PIN OUTS
rotcennoCdrakcaPihpleD
stcatnoC3
28774021N/ProtcennoC
49895021N/PlanimreT
desuFroloC
A
noitingielciheV
stloV21+
nepowolsA3
).xam(esuf
DER
BdnuorgelciheVKCALB
CevitcapmaldaeH
nepotsafA1
esuf
).xam(
EULB
rotcennoCdrakcaPihpleD
stcatnoc8
68874021N/ProtcennoC
76774021N/PlanimreT
A+aremaCRI
B-aremaCRI
CwoLoediV
DhgiHoediV
EniarDoediV
FdesUtoN
G-retaeHwodniW
H+retaeHwodniW
rotcennoCdrakcaPihpleD
stcatnoc8
88654021N/ProtcennoC
49895021N/PlanimreT
A+aremaCRI
BdnuorGaremaCRI
CwoLoediV
DhgiHoediV
EniarDoediV
FdesUtoN
G-retaeHwodniW
H+retaeHwodniW