Owner`s manual

USER SELECT PRIORITY CHANNEL
Press the PRI button on the keypad microphone to make the current
channel the fixed priority channel. The PR annunciator appears on the
display. This occurs in priority scan modes B, C, and D, but not A. See
"Priority Scan" on page 11.
USER SELECTED CODE GUARD
When the frequencies are programmed for each channel in the radio, a
receive Code Guard value and a transmit Code Guard value may also be
entered for each channel. The Code Guard values for channels 1 -9 can be
used for another channel in the radio. For example, to use the Code Guard
values of Channel 9 with the frequencies of Channel 5:
1. Turn off the SCN and PRI buttons.
2. Set the Channel Selector knob to Channel 5.
3. Press the 9 key on the keypad microphone. The CG annunciator
appears on the display to indicate that the Code Guard has been
changed from its original programming.
4. Press the 0 key to reset all values to the original settings, or press
a different number key to select a different set of Code Guard
values.
In numeric mode, the display shows the selected channel (Ch 5) with
the Code Guard value channel (9) to the right. The CG annunciator
appears on the display to indicate that the Code Guard has been
changed from its original programming.
In alphanumeric mode, the display shows the label for the Code Guard
value channel (ALPHA 9) briefly when changing to Channel 5, then the
display shows the label for the selected channel (ALPHA 5). The
CG annunciator appears on the display to indicate that the Code
Guard has been changed from its original programming.
EMH Owner’s Manual 9