Owner`s manual

[ TA ] Repeater Talk Around
Press the TA button to turn Repeater Talk Around on or off. When TA is on, the
radio transmits on the receive frequency of the selected channel, bypassing
or "talking around" the repeater. This function may be used on any channel
that is programmed to a frequency pair (repeater channel).
[NXT] Next Scan List Channel
Press the NXT button to select the next consecutive channel in the scan list
(not during scan operation). During Scan operation, press the NXT button to
select the most recent active channel.
[GRP] Channel Group
Press the GRP button to toggle between group select and channel select
modes. This is used only if the radio has been programmed to divide the
available channels into groups.
Press the GRP button for group select mode. Turn the Channel Select knob to
select a group. Return to channel select mode by waiting 5 seconds or by
pressing the GRP button one time (numeric mode) or two times (alphanumeric
mode). After selecting a group in alphanumeric mode, press the GRP button one
time to display the group label and a second time to return to channel select
mode.
[ACC] Accessory
Press the ACC button to turn the installed accessory on or off.
[SPK] Speaker
Press the SPK button to switch between the built-in radio speaker and an
optional remote speaker.
[CG] Code Guard Disable
Press the CG button to disable or enable Code Guard operation. An arrow on
the display points to the CG button when Code Guard is disabled. When
Code Guard is enabled, a message is heard only when the proper Code
Guard is received. Transmit Code Guard generation is unaffected. The CG
button may also be used to override Busy Channel Lockout, if that is installed.
See "Busy Channel Lockout Override" on page 13.
6 RELM/BK Radio