Technical data

B KY 96A, KY 97A
Rev 5, Apr 2003 MM 006-05674-0005.dwd Page 6-1
SECTION VI
ILLUSTRATED PARTS LIST
1000
6.1 INTRODUCTION
The Illustrated Parts List (IPL) contains parts lists of assemblies and discrete components re-
quired for the unit. The IPL provides the proper identification and part number of each replace-
ment part. The IPL starts with the top assembly and continues in sequence with the sub-as-
sembly parts lists. Mechanical parts are grouped separately from electrical parts on each sub-
assembly parts list. Each parts list is followed by the assembly drawing for that assembly.
Parts lists may also be called “bills of material” or “BOM.” Parts identified in this IPL meet de-
sign specifications for this equipment and are recommended replacement parts. Warranty in-
formation concerning replacement parts is contained in Service Memo #1, P/N 600-08001-
00XX.
6.2 BILL OF MATERIAL DESCRIPTION
This section describes the various items that may appear on parts lists. Refer to figure 6-0 for
the parts list format.
6.2.1 PARTS LIST (ASSEMBLY) NUMBER
Each parts list is labeled with the assembly part number at the top of the list. The assembly
number is followed by the assembly description and the revision level of the parts list.
6.2.2 SYMBOL COLUMN
The symbol column contains the reference designators of electrical components on the as-
sembly. Some mechanical parts and assembly supplies may be assigned the ITM designator.
Reference documents may be assigned the REF designator. The reference designator con-
tains a letter abbreviation to indicate the type of component, and the sequence number as-
signed to that part (C101, Q101, etc.). Common reference designator abbreviations are listed
in Table 6-1.
Table 6-1: Reference Designator Abbreviations
B Motor, Synchro
C Capacitor
CF Capacitor Filter
CJ Circuit Jumper
CQ Capacitor
CR Diode
D Diode
DS Lamp
E Terminal, Connect Point
F Fuse