Product Manual

4. Identify the correct cable button on the end of each

equalizer cable that corresponds to your desired lift

conguration. (See Fig 3.6) Secure the correct cable but-

ton at the lift head lock plate located inside each lift head.

5. Route the correct button end of the equalizer cable

for your chosen lift layout through the cable retainer,

located inside the lift head on the front lift head tube wall,

up to where the Top Plate sheave would be, and coil the

remaining cable up and leave it in the post above the lift

head. (See Fig 3.7-3.8)

6. If you have chosen the NARROW lift conguration,

secure cable button end by inserting cable into the desig-

nated cable clip. (See Fig 3.9)

7. Install the Top Plate Assembly using the M10 hardware

as provided in the Parts Bag. (See Fig 3.10)

NOTE FOR XPR-9S MODELS:

FOR NARROW CONFIGURATION USE THE

BUTTON LOCATED AT 12” ABOVE CABLE END.

FOR WIDE CONFIGURATION USE THE BUTTON

LOCATED ON THE END OF THE CABLE.

For narrow conguration

For wide conguration

To threaded

cable end

Fig 3.6

NOTE:

REFER TO STEP 10 FOR CABLE ROUTING DETAILS.

ROUTE BUTTON END OF CABLES PRIOR TO

RAISING UP THE POSTS.

FAILURE TO SECURE CABLE BUTTON FOR

NARROW LIFT CONFIGURATION MAY RESULT IN

LIFTING CHAIN FAILURE OR LIFT MALFUNCTION.

Fig 3.9

Cable Clip

NOTE: Portions of Lift Head and Post cut away for clarity

Fig 3.8

Towards Top

Plate Sheave

NARROW CONFIGURATION

NOTE: Portions of Lift Head and Post cut away for clarity

Fig 3.7

Towards Top

Plate Sheave

WIDE CONFIGURATION

NOTE: Portions of Lift Head and Post cut away for clarity