Product Manual

CLEARANCES

XPR-9S

STEP 5

(Installing the POWER SIDE post)

1. Before proceeding, double the check measurements

and make certain that the base plate of each post is

aligned with the chalk line.

2. Using the base plate on the POWER SIDE post as a

guide, drill each anchor hole in the concrete approximately

4” deep using a rotary hammer drill and 3/4” concrete drill-

bit. To ensure full holding power, do not ream the hole or

allow the drill to wobble. (See Fig. 5.1)

3. After drilling, remove dust thoroughly from each hole

making certain that the posts remain aligned with the chalk

line.

4. Assemble the washers and nuts on the anchors then

tap into each hole with a hammer until the washer rests

against the base plate. If shimming is required be sure that

enough threads are left exposed. (See Fig. 5.2)

NOTE:

BENDPAK LIFTS ARE SUPPLIED WITH INSTALLATION

INSTRUCTIONS AND CONCRETE FASTENERS

MEETING THE CRITERIA AS PRESCRIBED BY

THE AMERICAN NATIONAL STANDARD

"AUTOMOTIVE LIFTS - SAFETY REQUIREMENTS

FOR CONSTRUCTION, TESTING, AND VALIDATION"

ANSI/ALI ALCTV-2011. LIFT BUYERS ARE

RESPONSIBLE FOR ANY SPECIAL REGIONAL

STRUCTURAL AND/OR SEISMIC ANCHORING

REQUIREMENTS SPECIFIED BY ANY OTHER

AGENCIES AND/OR CODES SUCH AS THE UNIFORM

BUILDING CODE (UBC) AND/OR

INTERNATIONAL BUILDING CODE (IBC).

Fig 5.1

Fig 5.2

NOTE: Lift measurements shown in WIDE conguration

APPROACH

LIFT HEIGHT CLEARANCE NOTE: There must be 75” plus he height of

typical vehicle MIN distance from top of lift to nearest obstruction.

NOTE:

SUBTRACT 6-1/2” FROM MINIMUM NEAREST WALL

AND MINIMUM NEAREST BAY DIMENSION FOR

NARROW CONFIGURATION.