Product Manual

24
IMPORTANT POWER-UNIT INSTALLATION NOTES
n DO NOT run power unit without oil. Damage to pump can occur.
n The power unit must be kept dry. Damage to power unit caused by water or other liquids such as detergents,
acid etc., is not covered under warranty.
n Improper electrical connection can damage motor and will not be covered under warranty.
n Motor can not run on 50HZ without a physical change in the motor.
n Use a separate breaker for each power unit.
n Protect each circuit with time delay fuse or circuit breaker.
n For 208-230 volt, single phase, use a 25 amp fuse.
n For 208-230 volt, three phase, use a 20 amp fuse.
n For 380-440 volt, three phase, use a 15 amp fuse.
Installation and Adjustment
DO NOT attempt to raise vehicle until a thorough operation check has been completed.
DO NOT PERFORM ANY MAINTENANCE OR INSTALLATION OF ANY COMPONENTS
WITHOUT FIRST ENSURING THAT ELECTRICAL POWER HAS BEEN DISCONNECTED
AT THE SOURCE OR PANEL AND CANNOT BE RE-ENERGIZED UNTIL ALL
MAINTENANCE AND/OR INSTALLATION PROCEDURES ARE COMPLETED.
POWER-UNIT CONNECTION
ALL WIRING MUST COMPLY WITH NECK AND ALL LOCAL ELECTRICAL CODES.