Product Manual

27
POST-INSTALLATION CHECK-OFF
n Columns properly shimmed and stable
n Anchor Bolts tightened
n Pivot / Sheave Pins properly attached
n Electric power supply conrmed
n Cables adjusted properly
n Chain Links inspected and in good condition
n Safety Locks functioning properly
n Check for hydraulic leaks
n Oil level
n Lubrication of critical components
n Check for overhead obstructions
n All Screws, Bolts, and Pins securely fastened
n Surrounding area clean
n Operation, Maintenance and Safety Manuals
on site.
n Perform an Operational Test with a typical vehicle
STEP 15
(Lubrication)
1. After installation and start-up has been completed,
lubricate lift components as described below.
(See Fig. 15.1)
STEP 16
(Operation Instructions)
OWNER/EMPLOYER RESPONSIBILITIES
The Owner/Employer:
• Shall ensure that lift operators are qualied and that they
are trained in the safe use and operation of the lift using
the manufacturer’s operating instructions; ALI/SM01-1, ALI
Lifting it Right safety manual; ALI/ST-90 ALI Safety Tips
card; ANSI/ALI ALOIM-2000, American National Standard
for
Automotive Lifts-Safety Requirements for Operation,
Inspection and Maintenance; ALI/WL Series, ALI Uniform
Warning Label Decals/Placards; and in the case of frame
engaging lifts, ALI/LP-GUIDE, Vehicle Lifting Points/Quick
Reference Guide for Frame Engaging Lifts.
• Shall establish procedures to periodically inspect the
lift in accordance with the lift manufacturer’s instructions
or ANSI/ALI ALOIM-2000, American National Standard
for Automotive Lifts-Safety Requirements for Operation,
Inspection and Maintenance; and The Employer shall
ensure that lift
inspectors are qualied and that they are adequately
trained in the inspection of the lift.
• Shall establish procedures to periodically maintain the
lift in accordance with the lift manufacturer’s instructions
or ANSI/ALI ALOIM-2000, American National Standard
for Automotive Lifts-Safety Requirements for Operation,
Inspection and Maintenance; and The Employer shall
ensure that lift
maintenance personnel are qualied and that they are
adequately trained in the maintenance of the lift.
• Shall maintain the periodic inspection and maintenance
records recommended by the manufacturer or ANSI/ALI
ALOIM-2000, American National Standard for Automotive
Lifts-Safety Requirements for Operation, Inspection and
Maintenance.
Fig. 15.1
Lubricate
Sheaves
with light
Spray oil
Lubricate
Sheaves
with light
Spray oil
Lubricate
Safety Pins
with light Spray
oil
Lubricate four
inside corners
of Posts with
Light Axle
Grease
NOTE:
THERE WILL BE INITIAL STRETCHING OF THE
CABLES AND/OR WITH INCREASED LOADS. ADJUST
THE CABLES AS OUTLINED ABOVE A WEEK AFTER
FIRST USE, THEN EVERY THREE TO SIX MONTHS
THEREAFTER DEPENDING ON USAGE AND/OR
TO COMPENSATE FOR STRETCH.