Product Manual

30
LIFT OPERATION SAFETY (CONT’D)
4. Position vehicle for proper weight distribution arms
under vehicle to allow adapters to contact at the
manufacturer’s recommended pick up points.
5. If the specic vehicle lift points are not identied, refer
to the VEHICLE CENTER OF BALANCE instructions
found on our website at:
http://www.bendpak.com/support/balancing-safety/
6. Push the RAISE button or rotate the control switch on
the power unit.
7. Stop before making contact with vehicle. Check arm
restraint pins for engagement. If required, slightly move
arm to allow restraint gear and pawl to mesh. DO NOT
hammer arm restraint pin down as this will damage the
restraint gear teeth.
8. Raise vehicle until tires clear the oor.
9. Stop and check adapters for secure contact at vehicle
manufacturer’s recommended lift points.
10. Continue to raise to desired height only if vehicle is
secure on lift.
11. DO NOT go near or under a raised vehicle if all four
adapters are not in secure contact with vehicle at vehicle
manufacturer’s recommended lift points.
12. Repeat entire loading and raising procedures if
required.
13. Lower lift onto safety locks.
• DO NOT enter work area or go under vehicle if safety
locks are not engaged.
• CLEAR AREA if vehicle is in danger of falling.
• DO NOT position yourself between a wall and the lift.
If the vehicle falls in that direction, you may be severely
injured or killed.
• Before attempting to lift pickup trucks or other truck
frame vehicles, be sure that:
t Vehicle frame is strong enough to support its
weight and has not been weakened by
modication or corrosion.
TYPICAL LIFTING POINTS
NOTE:
ALLOW (2) SECONDS BETWEEN MOTOR STARTS.
FAILURE TO COMPLY MAY CAUSE MOTOR BURNOUT.
VISUALLY CONFIRM THAT ALL PRIMARY SAFETY
LOCKS ARE ENGAGED BEFORE ENTERING WORK
AREA. SUSPENSION COMPONENTS USED ON
THIS LIFT ARE INTENDED TO RAISE AND LOWER LIFT
ONLY AND ARE NOT MEANT TO BE LOAD HOLDING
DEVICES. REMAIN CLEAR OF ELEVATED LIFT
UNLESS VISUAL CONFIRMATION IS MADE THAT
ALL PRIMARY SAFETY LOCKS ARE FULLY ENGAGED
AND THE LIFT IS LOWERED ONTO THE SAFETY
LOCKS, REFER TO INSTALLATION /OPERATION
MANUAL FOR PROPER SAFETY