Use and Care Manual

!*"
"
All three have a cap to protect them from ingress of dirt.
To inflate an inner tube with a Sclaverand or road valve, proceed as follows:
Unscrew the valve cap anticlockwise with your fingers.
Unscrew the knurled nut anticlockwise.
Push the knurled nut with your finger briefly into the valve until air escapes.
Inflate the inner tube using a suitable tire pump.
Screw the knurled nut back down.
Screw the cap clockwise back onto the valve.
NOTE: Ask a specialist cycle shop for advice on which tire pump is suitable for your valve.
If you find any damage, DO NOT ride the bike.
Contact Customer Service.
Pedal Assist System
The first ride should be started with the Pedal Assist feature off and then slowly throttling to
feel the engagement of the HUB motor.
The Benelli by Buffalo Corp eBike Pedal Assist System supports you when riding, as long as
you are pedaling. Without pedaling, there is no assistance. The motor output always depends
on the amount of your pedaling power.
When applying less pedaling power, the assistance or support will be lower than when
applying a lot of pedaling power. This applies independent of the assistance Level. The eBike
drive automatically switches off at speeds in excess of 15.5 MPH. When the speed falls below
15.5 MPH the drive is automatically available again. An exception applies for the push
assistance function, in which the eBike can be pushed at low speed without pedaling. The