User Manual

6
5) Hold the stock-receiver unit with one hand
and the barrel-bolt unit with the other. Slide
the gas collector cylinder onto the cylinder
guide pin (fig. 7) at the same time sliding the
bolt backwards (fig. 8).
NOTE: the fins on the gas collector cylinder
must be lined up with the relative pins (fig. 9).
6) Lodge the end part of the cover into the re-
ceiver and push all the way in until the whole
unit clicks into place at stroke-end, and fits
snugly (fig. 10).
WARNING: as the bolt link passes over the trig-
ger guard it must fit itself into the recoil spring
tube inside the receiver (fig. 11).
7) Fit the barrel locking cap to the end of the
cylinder guide pin (fig. 12) and screw it on
fully, using the sling swivel pin of the fore-
end assembly (fig. 13).
10
8
9
7
11
12