Datasheet

2
B E N N I N G W o r l d C l a s s T e s t E q u i p m e n t
The international standard for voltage testers
IEC/EN 61243-3 (DIN VDE 0682-401):2011 increases
safety for work under voltage
Your work as an expert requires safe testing. Therefore, you
should not make any compromises concerning safety!
Voltage testers which are used on electrical systems of up to
1000 V have to comply with the standard IEC/EN 61243-3
(DIN VDE 0682-401):2011. The standard creates uniform
testing and safety criteria on an international level and re-
markably which concentrates on user safety.
The new generation of DUSPOL
®
voltage testers exceeds the
demands of the standards concerning both the protection cat-
egory for housings (IP 65) and overvoltage protection (CAT IV
600 V). The nominal voltage range has been increased to a
minimum of 1000 V AC/DC in order to ensure safe testing of
increased system voltages of industrial applications, photo-
voltaic systems and wind power plants as well as of hybrid
automotive engineering.
All DUSPOL
®
voltage testers are equipped with a direct display
system without loading the test point. In case of need, a load
circuit can be connected via a push-button which suppresses
inductive and capacitive reactive voltages. Thus, it is possible
to clearly distinguish between high-energy and low-energy
electric circuits.
A vibrating motor can be activated additionally. The vibrating
power of this motor increases proportionally to the applied volt-
age. This is an additional indication of voltage being app lied.
The DUSPOL
®
voltage testers underlines once again the
BENNING expertise in the field of testing, measu ring and
safety technology. With a DUSPOL
®
voltage tester you ac-
quire an innovative product which has been tested and ap-
proved by the independent VDE Test and Certification
Institute.
The new generation of DUSPOL
®
voltage testers
safe voltage testing up to 1000 V
1
0
0
0
V
A
C
/
DC
1
0
0
0
V
A
C
/
DC
1
00
0
V
A
C
1
2
0
0
V
DC
DUSPOL
®
voltage testers
The original!
Product safety at the highest level:
• safe voltage testing up to 1000 V AC/DC
• direct display without actuating a push-button
(high-impedance testing)
• load connection via push-button
(low-impedance testing)
• battery-independent voltage indication
from 50 V AC/DC on
• vibration alert in the test handle
• robust round housing with rubberized gripping
surface for outdoor use (protection category IP 65)
• tested and approved in compliance with the current
DIN EN 61243-3 (VDE 0682-401):2011 standard
Stand-by case
010911
(see page 18)
DUSPOL
®
analog DUSPOL
®
expert
CAT IV 600 V CAT IV 600 V
DUSPOL
®
digital
CAT IV 600 V