User's Manual

BENQ Corporation
35
Chapter 4. TroubleShooting
Question 1
What should the users do when the signal icon Cable Disconnected
appeared right after pressing the ReScan or Disable Radio button under
Peer-to-Peer (Ad-hoc) mode?
Answer 1
Please remove the BenQ W10 PC Card from the PCMCIA slot and re-insert
the device again, and then it will connect the user back on line.
Question 2
What if the user’s PC is unable to connect to the other PC right after
switching the network type from access point mode to Peer-to-Peer mode?
Answer 2
Please make sure the SSID for both PC are the same and the IP address are
in the same subnet. If both SSID and IP address are checked and the same,
but the PC is still in disconnection mode, then please remove the BenQ W10
PC Card from the PCMCIA slot and re-insert the device again to connect
back online.
Question 3
What if the users lost connection due to distance, but still unable to connect
to each other after move both devices closer under Peer-to-Peer (Ad-hoc)
mode?
Answer 3
Please remove the BenQ W10 PC Card from the PCMCIA slot and re-insert
the device again, and then it will connect the devices back on line.
Question 4
What if the user is unable to alliance with the new association after moving
from one AP service set to another under the Access Point (Infrastructure)
mode?
Answer 4
Please ensure that the SSID is the same for both APs and PC. If the SSID
is correct, then please press the ReScan button in the Status menu, and then