User Manual
Table Of Contents
- Copyright
- Disclaimer
- BenQ ecoFACTS
- Introduction
- Installation
- Environment check
- Assembling the InstaShow Host
- Setting up the InstaShow Host
- Positioning the InstaShow Host antennas
- Connecting the HDMI cable and power
- Setting up and powering an InstaShow Button
- Pairing a InstaShow Button and InstaShow Host
- Waking up the InstaShow Host
- Storing InstaShow Buttons in the cradle
- Resetting a InstaShow Host
- Resetting a InstaShow Button
- Starting and stopping presentations
- Web management
- Troubleshooting
11 Installation
Assembling the InstaShow Host
Assemble the InstaShow Host with two antennas by turning the antennas clockwise (right) and
counterclockwise (left) to fasten them tightly.
Setting up the InstaShow Host
You are provided with four different ways to position the InstaShow Host. The total weight of the
InstaShow Host Unit is 150g.
Attaching the InstaShow Host to the ceiling
1. Place the lid on the ceiling and locate the alignment hole.
2. Use the screws provided to lock the lid to the ceiling.
3. Lock the first hole (1).
4. Follow the instruction in the illustration below to lock the other holes (2-4).
5. Rotate the InstaShow Host counterclockwise to affix the InstaShow Host to the lid.
Attaching the InstaShow Host to a ceiling mount
If the display is mounted on the ceiling:
• Please only use the screws (M3*16 tapping screw) provided with the kit to mount the InstaShow Host to the
ceiling.
• Please see Positioning the InstaShow Host antennas on page 15 for guidelines on positioning the antenna to
maximize signal reception.
open lock
open lock
1
2
34
open lock
Alignment
hole