User Manual
Table Of Contents
- Copyright
- Disclaimer
- BenQ ecoFACTS
- Introduction
- Installation
- Environment check
- Assembling the InstaShow Host
- Setting up the InstaShow Host
- Positioning the InstaShow Host antennas
- Connecting the HDMI cable and power
- Setting up and powering an InstaShow Button
- Pairing a InstaShow Button and InstaShow Host
- Waking up the InstaShow Host
- Storing InstaShow Buttons in the cradle
- Resetting a InstaShow Host
- Resetting a InstaShow Button
- Starting and stopping presentations
- Web management
- Troubleshooting
16 Installation
• Avoid positioning the antennas in a horizontal manner, this may result in a weak signal reception:
• If the InstaShow Host is attached to a metallic ceiling mount ensure that the antennas are at least 3
cm away from the metal portion of the ceiling mount:
For table placement
Position the antennas so that they are both pointed upwards roughly perpendicular to the table:
Connecting the HDMI cable and power
Once the InstaShow Host has been positioned properly near the display, connect the HDMI cable and
power to ensure signal transmission.
To supply power to the InstaShow Host, do one of the following.
Assemble the adapter. See Assembling the adapter on page 17 for details.
• Some BenQ projector models may be equipped with a USB type A jack (5V/1.5A) to provide power
supply to the InstaShow Host. See Power supply via a USB type A jack (5V/1.5A) on page 18 for
details.
• For display models without a USB type A jack (5V/1.5A) for power supply, see Power supply via a
power adapter on page 19 for details.
3 cm3 cm