User Manual
Table Of Contents
- Copyright
- Disclaimer
- BenQ ecoFACTS
- Introduction
- Installation
- Environment check
- Assembling the InstaShow Host
- Setting up the InstaShow Host
- Positioning the InstaShow Host antennas
- Connecting the HDMI cable and power
- Setting up and powering an InstaShow Button
- Pairing a InstaShow Button and InstaShow Host
- Waking up the InstaShow Host
- Storing InstaShow Buttons in the cradle
- Resetting a InstaShow Host
- Resetting a InstaShow Button
- Starting and stopping presentations
- Web management
- Troubleshooting
20 Installation
2. The LED indicator of the InstaShow Button will turn red while the InstaShow Button is starting
up.
3. When the InstaShow button is ready to present, the LED indicator will turn green. Press the
Present key when the LED indicator turns green.
If you purchase an additional InstaShow Button (via an InstaShow Button Kit), please follow the
process described below:
1. Connect the InstaShow Button’s USB-C™ jack to the corresponding input of a laptop. See the
illustration.
• Handle the InstaShow Button cable with care. Rough handling might cause defects.
• Pull/Push the plug instead of the cable when inserting or removing InstaShow Buttons.
USB-C™
MODE