User Manual
Table Of Contents
- Copyright
- Disclaimer
- BenQ ecoFACTS
- Introduction
- Installation
- Environment check
- Assembling the InstaShow Host
- Setting up the InstaShow Host
- Positioning the InstaShow Host antennas
- Connecting the HDMI cable and power
- Setting up and powering an InstaShow Button
- Pairing a InstaShow Button and InstaShow Host
- Waking up the InstaShow Host
- Storing InstaShow Buttons in the cradle
- Resetting a InstaShow Host
- Resetting a InstaShow Button
- Starting and stopping presentations
- Web management
- Troubleshooting
28 Installation
2. Poke the RESET hole at the bottom of the InstaShow Button with a pin for at least 2 seconds.
3. The InstaShow Button LED will begin quick flashing red (flash red twice every second) for 10
seconds, then light up static red for 15 to 20 seconds, indicating that the InstaShow Button is
resetting.
4. Once the InstaShow Button LED flashes red the resetting process is complete.
Do not disconnect the InstaShow Button from its power source at any time during the resetting process.