User Manual
Table Of Contents
- Copyright
- Disclaimer
- BenQ ecoFACTS
- Introduction
- Installation
- Environment check
- Assembling the InstaShow Host
- Setting up the InstaShow Host
- Positioning the InstaShow Host antennas
- Connecting the HDMI cable and power
- Setting up and powering an InstaShow Button
- Pairing a InstaShow Button and InstaShow Host
- Waking up the InstaShow Host
- Storing InstaShow Buttons in the cradle
- Resetting a InstaShow Host
- Resetting a InstaShow Button
- Starting and stopping presentations
- Web management
- Troubleshooting
37 Web management
Logging into the web management interface via LAN
If your InstaShow Host is connected to your LAN, you can enter the IP Address shown on the
screen via a web browser.
Depending on the HTTP over SSL setting from Advance Setting (see page 53), different
communication protocol is used to log into web management.
• HTTP over SSL is On, enter https://<InstaShow Host IP address>. Ignore the warning
message if it says your connection is not private or secure. The data encryption is activated once
this function is enabled. The warning message is displayed because you browser expects an SSL
certificate from certain authorities to verify the connected device. The self-signed certificate
generated by InstaShow Host does not meet the default security policy.
• HTTP over SSL if Off, enter http://<InstaShow Host IP address>.