User Manual
Table Of Contents
- Copyright
- Disclaimer
- BenQ ecoFACTS
- Introduction
- Installation
- Environment check
- Assembling the InstaShow Host
- Setting up the InstaShow Host
- Positioning the InstaShow Host antennas
- Connecting the HDMI cable and power
- Setting up and powering an InstaShow Button
- Pairing a InstaShow Button and InstaShow Host
- Waking up the InstaShow Host
- Storing InstaShow Buttons in the cradle
- Resetting a InstaShow Host
- Resetting a InstaShow Button
- Starting and stopping presentations
- Web management
- Troubleshooting
45 Web management
After you configure all the Wireless Network settings, press Apply to proceed.
Pairing
Click Pairing and you will see Pairing and Pairing Status.
Pairing is used when the InstaShow Host is attached to the ceiling as it is not easy to press the
PAI RING key of the InstaShow Host when the device is high on the ceiling. You can pair a InstaShow
Button and InstaShow Host via the web management interface. See Advance Setting on page 48 for
more information about EDID status.