User Manual
Table Of Contents
- Copyright
- Disclaimer
- BenQ ecoFACTS
- Introduction
- Installation
- Environment check
- Assembling the InstaShow Host
- Setting up the InstaShow Host
- Positioning the InstaShow Host antennas
- Connecting the HDMI cable and power
- Setting up and powering an InstaShow Button
- Pairing a InstaShow Button and InstaShow Host
- Waking up the InstaShow Host
- Storing InstaShow Buttons in the cradle
- Resetting a InstaShow Host
- Resetting a InstaShow Button
- Starting and stopping presentations
- Web management
- Troubleshooting
46 Web management
1. Connect the InstaShow Button’s USB-C™ jack to the corresponding port of a laptop.
2. When the InstaShow Button is successfully connected to the laptop, the LED indicator of the
InstaShow Button will blink red.
3. Make sure the InstaShow Host is properly connected to a power source.
4. Press start pairing to pair the InstaShow Host to the InstaShow Button via the web
management interface, you will have two minutes to pair with the InstaShow Button.
USB-C™
MODE