User Manual
Table Of Contents
- Copyright
- Disclaimer
- BenQ ecoFACTS
- Introduction
- Installation
- Environment check
- Assembling the InstaShow Host
- Setting up the InstaShow Host
- Positioning the InstaShow Host antennas
- Connecting the HDMI cable and power
- Setting up and powering an InstaShow Button
- Pairing a InstaShow Button and InstaShow Host
- Waking up the InstaShow Host
- Storing InstaShow Buttons in the cradle
- Resetting a InstaShow Host
- Resetting a InstaShow Button
- Starting and stopping presentations
- Web management
- Troubleshooting
51 Web management
You are suggested to have EDID Management On to sync the EDID of the InstaShow Button and
the display. If you have EDID Management Off, EDID will not be changed. If you have EDID
Management Reset, EDID will be restored to factory default setting.
Standby Mode allows you to set the conditions that place the InstaShow Host in standby. You can
have your Standby Mode Off to prevent the InstaShow Host from going into standby or choose
between Network Standby Mode and HDMI Standby Mode.
Network Standby Mode disables the HDMI output from the InstaShow Host after a set amount of
time in which there is no connection with an InstaShow Button. When the InstaShow Host is in
Setting Description
On (Default) InstaShow™ automatically configures the source notebook's
resolution setting to match the display device pixel-by-pixel for
perfectly clear picture quality.
Off InstaShow™ do not configure the source notebook's resolution
setting to match the display device pixel-by-pixel for perfectly clear
picture quality.
Reset EDID will be restored to factory default setting.