User Manual
Table Of Contents
- Copyright
- Disclaimer
- BenQ ecoFACTS
- Introduction
- Installation
- Environment check
- Assembling the InstaShow Host
- Setting up the InstaShow Host
- Positioning the InstaShow Host antennas
- Connecting the HDMI cable and power
- Setting up and powering an InstaShow Button
- Pairing a InstaShow Button and InstaShow Host
- Waking up the InstaShow Host
- Storing InstaShow Buttons in the cradle
- Resetting a InstaShow Host
- Resetting a InstaShow Button
- Starting and stopping presentations
- Web management
- Troubleshooting
53 Web management
• The power cable connected to the InstaShow Host is disconnected then reconnected.
To increase security, you can select On from HTTP over SSL to encrypt your content transmitted
between the server and the browser. And you can hide SSID and IP on standby screen by setting
Hide Standby Screen SSID and IP to On.
After you configure all the Advance Setting items, press Apply to proceed.
If you want to restart the InstaShow Host, press Restart and a window will pop up. Press OK to
proceed.
If you want to shutdown the InstaShow Host, press Shutdown and a window will pop up. Press OK
to proceed.
• In cases where users want to conserve energy, Network Standby Mode is a suitable mode as the power
consumption for a display (e.g. projectors, TVs, monitors, etc.) is usually greater than the power consumption
for the InstaShow Host (5V/1.5A).
• In cases where the InstaShow Host is attached to a ceiling or the power button is out of reach by the user,
HDMI Standby Mode is a suitable mode as it allows the user to power off the InstaShow Host by powering
off the display.