User`s manual

BenQ DC 5530 User’s Manual

English

Using the DC C800 5

USING THE DC C800

3.1 Turning the Power On and Off

1. Press the POWER button to turn on the camera in

the Record mode. Or you can press the button to

turn on the camera in the Playback mode.

2. Press the POWER button again to turn the power off.

• You can turn on the camera without the start-up and

operating sound by pressing and holding the POWER

or the button for over 1.5 seconds.

3.2 Power Saving Function

If the camera is turned off by Power Save feature, press the POWER or the button to turn

it on again.

The Power Save feature does not work in the following situations:

• Connecting the camera to a computer or printer with the USB cable.

• Connecting the camera with the AC adapter (sold separate).

• About the Power Save operation, refer to 3.16.3 “Setting the Power Save” on page 22.

3.3 Switching between Record and Playback

You can switch between Record mode and Playback mode in following ways:

3.3.1 In Record mode

•

Press the MODE button to cycle through the still image shooting, voice recording,

and movie recording.

• Press the button to switch to the Playback mode.

• If you switch to Playback mode, the lens will retract after approximately 10 seconds.

3.3.2 In Playback mode

Press the MODE or the button switch to the previous used Record mode.

Press down halfway

Press down fully

DC_C800_UM.book Page 5 Friday, October 21, 2005 2:58 PM

Downloaded From camera-usermanual.com BenQ Manuals