User manual
Table Of Contents
- Copyright
- Disclaimer
- Please follow these safety instructions for best performance, and long life for your monitor
- 1. Getting started
- 2. Getting to know your monitor
- 3. How to assemble your monitor hardware
- 4. Getting the most from your BenQ monitor
- 5. Picture optimization
- 6. How to adjust your monitor
- 7. Troubleshooting
8 How to assemble your monitor hardware
2. Connect the PC video cable
To Connect the D-Sub Cable
Connect the plug of the D-Sub cable (at the end without
the ferrite filter) to the monitor video socket. Connect the
other end of the cable (at the end with the ferrite filter) to
the computer video socket.
Tighten all finger screws to prevent the plugs from acci-
dently falling out during use.
To Connect the DVI-D Cable
Connect the plug of the DVI-D cable (at the end without
the ferrite filter) to the monitor video socket. Connect the
other end of the cable (at the end with the ferrite filter) to
the computer video socket.
Tighten all finger screws to prevent the plugs from acci-
dently falling out during use.
To Connect the HDMI Cable
Connect the plug of the HDMI cable to the monitor video
socket. Connect the other end of the cable to the computer
video socket.
The video cable included in your package and the socket
illustrations on the right may vary depending on the LCD
model.
DVI-D is only available in models E900HD, M2200HD,
E2200HD, M2400HD, and E2400HD. HDMI is only
available in models M2200HD, E2200HD, M2400HD and
E2400HD.
3. Connect the audio cable. (Optional)
Connect the audio cable between the socket on the rear of
the monitor and your computer audio outlet.
You may connect headphones to the headphone jack
found on the left side of the monitor. See picture on the
right.