Operation Manual

Operation
28
Switching input signal
Selecting an input source
The projector can be connected to multiple devices
at the same time. However, it can only display one
full screen at a time. Press / on the projector
or remote control to select your desired input
signal.
• The input signal type affects the options available
for the Picture Mode. See "Selecting a picture
mode" on page 35 for details.
• The native display resolution of this projector is in
16:10 aspect ratio. For best display picture results, you should select and use an input signal
outputting at this resolution. Any other resolutions will be scaled by the projector
depending upon the 'aspect ratio' setting, and this may result in image distortion or loss of
picture clarity. See "Selecting the aspect ratio" on page 34 for details.
Setting quick auto search
To set your projector to automatically search for input signals:
1. Go to Settings > Basic > Quick Auto Search menu, press OK, and a pop-up
menu appears.
2. Select On and press OK.
3. To leave the OSD menu, press or .
Changing color space
In the unlikely event that you connect the projector to a DVD player via the projector’s
HDMI input and the projected picture displays wrong colors, please change the color space
to YUV.
1. Press and press to highlight Color Space Conversion and press OK, a pop-
up menu appears.
2. Select a suitable color space and press OK.
This function is only available when the HDMI input port is in use.