User Manual

37
________________________________________________________________
V1.1
14 / 20 Commercial Display RS-232 Protocol
002: Passthrough Master
Note: To set Pass through, the command
must use the "With ID protocal", and the ID
should between "01"~"98".
003: Passth
rough Slave
Note1: To set Pass through, the command
must use the "With ID protocal", and the ID
should between "01"~"98".
Note2: The monitor will not response to any
RS232 command if it is at Passthrough Slave
mode
Button&IR
Control
8
g
69
000: Disabl
e
All the buttons at both keypad board and
remote controller have no function.
001: Enable
Video Source
8
g
6A
000 : VGA
If PIP or PBP=On, the return value is the
source at active window.
001 : HDMI1
002: HDMI2
Option, not support if the platform doesn't
have this feature.
003 : AV
Option, not support if the platform doesn't
have this feature.
004 : YPbPr
005 : S
-
Video
Option, not support if the platform doesn't
have this feature.
006 : DVI
007 : DisplayPort
008 : SDI
Option, not support if the platform doesn't
have this feature.
009 : Multi
-
Media
Option, not support if the platform doesn't
have this feature.
010:Network
Option, not support if the platform doesn't
have this feature.
011: USB Display
Option, not support if the platform doesn't
have this feature.
Power
8
g
6C
000: Standby
001: On
5V
8
g
6D
~050
value=049 means 4.9V
12V
8
g
6
E
~120
value=122 means 12.2V
Ambient
Sensor Value
10
g
70
00000 ~ 2000
Ex: If the value is 500, the return value should
be:
Byte1=0x30, Byte2=0x35, Byte3=0x30,
Byte4=0x30, Byte5=0x30.