User's Manual

36 Maintenance

10. Tighten the screw(s) that secures the lamp.

11. Ensure the handle is fully laid flat and locked in place.

12. Connect the lamp connector.

13. Put the safety mylar back to the top.

14. Replace the lamp cover on the projector.

15. Tighten the screw that secures the lamp cover.

16. .Connect the power and restart the projector.

Resetting the lamp timer

17. After the startup logo, open the On-Screen Display

(OSD) menu. Go to SYSTEM SETUP: ADVANCED Menu > Lamp Settings and press OK.

The Lamp Settings page appears. Highlight Reset Lamp Timer and press OK. A warning

message is displayed asking if you want to reset the lamp timer. Highlight Reset and press OK. The

lamp time will be reset to “0”.

• Loose screw may cause a bad connection, which could

result in malfunction.

• Do not over tighten the screw.

• Loose screw may cause a bad connection, which could

result in malfunction.

• Do not over tighten the screw.

Do not reset if the lamp is not new or replaced as this could cause damage.