User Guide
Table Of Contents
- Table of contents
- Important safety instructions
- Projector features
- Positioning your projector
- Connection
- Operation
- Menu Functions
- About the OSD Menus
- Using the Basic OSD menu
- Using the Advanced OSD menu
- Securing the projector
- Utilizing the password function
- Switching input signal
- Picture menu
- Audio Setup menu
- Display menu
- System Setup : Basic menu
- System Setup : Advanced menu
- Information menu
- Shutting down the projector
- Advanced OSD menu structure
- Maintenance
- Troubleshooting
- Specifications
- Warranty and Copyright information
Operation32
Fine-tuning the image size and clarity
1. Adjust the projected image to the size that you
need using the Z O O M slide lever.
2. Then sharpen the image by rotating the FO CUS
ring.
Correcting keystone
Keystoning refers to the situation where the projected image is noticeably wider at either
the top or bottom. It occurs when the projector is not perpendicular to the screen.
You may correct this in O N E of these ways.
• Using the remote control
Press KEYSTON E to display, the 2D Keystone window.
• Using the projector
Press ▲, ▼, ◄ or ► to display the 2D Keystone window.
• W hile the Auto V-Keystone is On
•Press BACK for 2 seconds to
reset the Horizontal keystone
value
•Press ▲/▼ to turn off Auto V-
Keystone
• W hile the Auto V-Keystone is Off
•Press OK for 2 seconds to turn
on Auto V-Keystone
•Press BACK to reset the Vertical
& Horizontal keystone value