Operation Manual
English
17
Effective range of remote control
Infra-Red (IR) remote control sensors are located on the front and rear of the projector. The remote
control must be held at an angle within 30 degrees perpendicular to the projector's IR remote control
sensor to function correctly. The distance between the remote control and the sensor should not
exceed 8 meters (~ 26 feet).
Ƞ
30Ƀ
Approx. ±30°
Replacing the remote control battery
1. To open the battery cover, turn the remote control over to view its back, push on the nger grip on
the cover and slide it up in the direction of the arrow as illustrated. The cover will slide off.
2. Remove any existing batteries (if necessary) and install two AAA batteries observing the battery
polarities as indicated in the base of the battery compartment. Positive (+) goes to positive and
negative (-) goes to negative.
3. Ret the cover by aligning it with the base and sliding it back down into position. Stop when it clicks
into place.
Caution:
y Avoid excessive heat and humidity.
y There may be battery damage if the battery is incorrectly replaced.
y Replace only with the same or equivalent type recommended by the battery manufacturer.
y Dispose of the used battery according to the battery manufacturer’s instructions.
y Never throw a battery into a re. There may be danger of an explosion.
y If the battery is dead or if you will not be using the remote control for a long time, remove the battery to prevent damage to
the remote control from possible battery leakage.