Operation Manual
English
27
Operation
Starting up the projector
1. Plug the power cord into the projector and into a power
outlet. Turn on the power outlet switch (where tted). Check
that the POWER indicator light on the projector lights
orange after power has been applied.
Please use the original accessories (e.g. power
cable) only with the device to avoid possible
dangers such as electric shock and re.
2. Press POWER on the projector or on the remote control to turn on the projector.
Now you will hear the start sound. The POWER indicator light ashes and stays green when
the projector is on. The start up procedure takes about 30 seconds. In the later stage of start up, a
startup logo is projected.
(If necessary) Rotate the focus ring to adjust the image clearness.
To turn off the ring tone, refer to “Power On/Off Ring Tone” on page 43 for details.
3. To use the OSD menus, please set them to your familiar
language rst.
4. If you are prompted for a password, press the arrow keys to
enter a six digit password. See “Utilizing the password function”
on page 32 for details.
Language
Enter
Conrm
MENU
Exit
5. Switch all of the connected equipment on.
6. The projector will start to search for input signals. The current input signal being scanned displays in
the upper left corner of the screen. If the projector doesn't detect a valid signal, the message “No
Signal” will continue displaying until an input signal is found. You can also press SOURCE on the
projector or remote control to select your desired input signal. See “Switching input signal” on page 34
for details.
If the frequency/resolution of the input signal exceeds the projector's operating
range, you will see the message “Out of Range” displayed on a blank screen. Please
change to an input signal which is compatible with the projector's resolution or set
the input signal to a lower setting. See “Timing chart” on page 70 for details.